To begin this synthesizer we grabbed all of our needed materials shown in the picture. Next I took out all the materials and laid them onto a piece of white paper where I labeled each part. From my teardown and after learning about classmates' teardowns I understood each part. As seen in the picture: There are four resistors, two 1M, and the others 5k and1k. In general, resistors control the amount of energy that can flow. Three capacitors of 0.01uF, 0.1uF and 10uF. Overall, capacitors are used to store charge and smooth out circuits. The other parts are a wire, a speaker, a switch (to turn the synthesizer on and off) and the breadboard (used to assemble the circuit). And the 556 chip has two timers in it that control oscillation and vibration.
0 Comments
Leave a Reply. |
AuthorArchives
March 2018
Categories |