We are creating a rocket with the 3D printer using Onshape. The first step is creating the fuselage: the middle body of the rocket. Following the tutorial was not easy at times and when I messed up I would go back and redo the directions from a certain point. On the other hand, the gifs in the tutorial were very helpful; allowing me to see how the model is supposed to look like. My two main problems were making the extrudes and putting the fuselage on section view. To fix the extrudes I went back a few steps and followed the directions closely, and the problem was fixed. I must have had the wrong part selected because at first the extrude turned red (meaning it wasn't working). For the section view, the selection made the right panel of my screen black and orange. It was hard for me to see the sliced middle body, unlike the gif shown, because it impaired my view. I left the weird black panel alone and finished the directions that required section view, it was hard but manageable. Below is a screenshot of the rocket's middle body and a link to the tutorial:
http://www.stageoneeducation.com/cad-tutorial/index.html
0 Comments
Leave a Reply. |
AuthorArchives
October 2018
Categories |