The next step to creating the Onshape rocket was adding the fins and boosters to the middle body. This part of the tutorial was a little longer than the previous middle body section. Overall the steps were easy to follow and I successfully connected the fins and boosters with only one mishap. After making the launch pad connector I followed the directions to fillet the top and sides of the opening, the top worked fine but when it came to putting a fillet on the sides that section read error. I continued to redo that portion but it didn't work until I came to class and received help from my teacher. The rest of the fins and booster tutorial was completed without problem. The fins and booster connected to the middle body is shown below:
Onshape Rocket Tutorial: http://www.stageoneeducation.com/cad-tutorial/lower-body1.html
0 Comments
Leave a Reply. |
AuthorArchives
October 2018
Categories |