Using the onshape tuturial made it simple and manageable to create this rocket. The 3D printing of the three parts went smoothly and all that was left to do was assemble the rocket. Putting the rocket together was not too difficult although, it did require patience when it came to pulling the elastic through a small hole in the body. The rocket was read to launch but, unfortunately on launch day the rocket did not work. This hiccup was probably due to the wire not touching the engine. After the engine is replaced, it's bound to work. Below are pictures of the 3D rocket.
0 Comments
Leave a Reply. |
AuthorArchives
October 2018
Categories |